![]() Once within +/- 1 at 13.3-13.4, hit the big up arrow on the bottom right to send to the ECU. Adjust the arrows (by the number 100) left to subtract, right to add fuel. You want the amount of fuel correction (Fuel_CL) at 13.3-13.4 to be 1 to -1 (within that range). The amount will be 100 (which is the stock amount) with a left and right arrow. ![]() Let the bike warm to 60 Celsius (140 F) (Important).ħ. Turn on your ignition and make sure Auto Tune and WB O2 CL are off in the Calibration menu. Hit Start Learning, then hold the throttle all the way open until it says that learning is complete. Set throttle position (TPS), Swipe from left to bring up the menu, Calibration > Scroll down to TPS Learn. Once connected, do NOT turn on your engine yet!Ĥ. Turn the key on, let the ARacerSmart software connect again. Turn to the off position and leave it off for 10 seconds (important), every time you shut off the motorcycle for at least 10 seconds, the ECU has the current settings written to it.ģ. After it reaches 100% (takes about 5 minutes or a little more), you will see your bike reset and hear your fuel pump activate (like when you first turn the key to the on position). As it is burning, make sure your keep your phone in range and you should see the percentage move up as your dash lights flash. Pick the tune closest to your setup, then let it burn. Swipe from left to pull up the menu and go to Quick Burn. If not, close it and re-open it (on your PC or smartphone).Ģ. ![]() Turn your key on and do NOT start the bike, open the aRacerSmart software and it should connect to your bike. Updated - Clarified a few of the steps.ġ. Always hit the up arrow after setting your values. NOTE: (Important) The up arrow in the function menus sends the value to store in the ECU, the down arrow recalls the current setting of the ECU. ![]()
0 Comments
Leave a Reply. |